Configuring Basic Router Part-3 (Finish)

The Show Command List below are mostly used in my daily job.You can see it at Previledge mode.

• show interfaces – Displays all the statistics for all the interfaces on the router. To view the statistics for a specific interface, enter the show interfaces command followed by the specific interface and port number.
• show controllers serial – Displays information-specific to the interface hardware
  
• show clock – Shows the time set in the router
• show hosts – Displays a cached list of host names and addresses
• show users – Displays all users who are connected to the router
• show history – Displays a history of commands that have been entered
• show flash – Displays information about flash memory and what IOS files are stored there
• show version – Displays information about the router and the IOS that is running in RAM
• show ARP – Displays the ARP table of the router
• show protocol – Displays the global and interface specific status of any configured Layer 3 protocols
• show startup-configuration – Displays the saved configuration located in NVRAM
• show running-configuration – Displays the configuration currently running in RAM

This is the end of Configuring basic router.Please give comment and to my blog. I'm very apreciate it :)

Source :
www.cisco.com